New Product Post21 – FlowerPad-NoPlated
Compared with other versions of FlowerPad, the obvious changes of this board is No Plated through pad. It means pads on different layer are independent,and you can wire on double sides. We think it will make you build a more complex project on protoboard easily.
At the same time, FlowerPad – NoPlated ProtoBoard has a larger size, about 225x68mm .
- Flower-shaped pad
- NoPlated Pad
- Standard 2.54mm(100mil) spaced holes
- 1mm Hole size
- Black PCB
- Easy to use point-to-point wiring, need less solder
This is a half size breadboard, good for small projects. It’s 165 x 55 mm with a standard double-strip in the middle and two power rails on both sides. You can pull the power rails off easily to make the breadboard as thin as 3.5cm and stick it onto an Arduino protoshield. You can also cut these in half with a saw to create 2 tiny breadboards, or “snap” these breadboards together either way to make longer and/or wider breadboards.
- Dimensions: 165 x 55 mm
- Horizontal: 1-30
- Vertical: A-J
- 2 power lanes
KeyPad – 4×4 button [5.9]
A basic 16 button keypad for user input. The buttons are setup in a matrix format. This allows a microcontroller to ‘scan’ the 8 output pins to see which of the 16 buttons is being pressed.
- Weight: 10 grams
- Keypad dimensions: 50mm x 44mm x 1.6mm
- 8-pin 0.1″ pitch connector