Your cart is empty

Octopus Photo Interrupter Sensor

  • Model: EF04012
  • Shipping Weight: 4g
  • 161 Units in Stock

Octopus Electronic Bricks, you can use them build electronics projects just as easy as piling bricks. By using Octopus electronic bricks, you may connect Arduino/Freaduino compatible boards easily with various digital, analog and I2C/Uart interfaces. These the breadboard-less firm connection are prepared to extensive modules like poteniometers, sensors, relays, servos...even buttons, just plug and play.

Photo Interrupter Sensor is a sensor module based on ITR9608 photoelectric switch, together with special Arduino shield in use.It has been widely used in parts counting, motor speed and so on. Three pins electronic building blocks interface, input 5V - GND, S for digital signal output.


  • Use ITR9608 photoelectric switch, with a built-in infrared emitting tube and a receiving tube.
  • With signal LED: a signal indicator. (when there are objects standing in the middle of the groove ITR9608 photoelectric switches, the signal LED is off)
  • Operating voltage: DC 5.0V
  • Power supply needs: 5V
  • Interface type: Digital
  • Pin Definition: 1-Signal 2-VCC 3-GND
  • Fast response and High sensitivity
  • Simple drive circuit
  • Stable and long life

  • xxx

    Shipping List
  • 1 x Photo Interrupter Sensor Brick
  • 1 x Analog Sensor Cable

  • Documents:

  • Schematics

  • Please visit our wiki page for more info about this product. It will be appreciated if you can help us improve the documents, add more demo code or tutorials.

    This product was added to our catalog on Tuesday 25 June, 2013.