Installation Guide For Tiny

Installation Guide For Tiny

Hi, dear friends, from the date of establishment, ElecFreaks has released a wide range of products,  and fortunately attained substantial attention and support , meanwhile, we also received lots of emails seeking for technical support from hobbyists all over the world. So we undertake to enrich our tutorials in diversified form, including text, picture, video, and so on. Following the launch of installation guide for 2WD and 4WD, currently we updated the guide for TINY. Although it is  the same as the previous ones to a certain degree, we are available to consider it as a complementary way to consolidate the series guide.

Part Introduction

Part 1:  Smart car floor x 1.

Part 2 Smart car wheel x 2

part 3 :Caster  x1

part 4 :Encoder disk  x 2

part 5: Acrylic fastener x 4

Part 6 : Geared Motor  x 2.

part 7 :M3 * 28 Screw x 2

part 8 :M3 Screw nut x 15

part 9 :M3 * 13MM + 6  Copper cylinderx  4

part 10 :M3 * 7.5 Cap screw x 10  

Step 1

Firstly assemble the encoder disk with the geared  motor as illustrated above. Drop some glue if necessary (not too much because the motor can’t work if it is too sticky—–pay special attention )

Step 2

Place the acrylic fastener in the position as demonstrated  above and put  the well-prepared motor installed just now into the corresponding position.

Step 3

Let the M3*28 screws  go through the motor and the acrylic fastener, normally from outside to inside ,  and from upside to downside, but if you get the M3*30 screws, try to operate them from the other direction.

Step 4

Fix the motor in the other end with another fastener and two screw nuts .

Step 5

Connect the wheel with the fixed geared motor.

Step 6

Now let's install the caster. Assemble the caster with four screw nuts and four M3 * 13MM + 6  copper cylinders as above.

Step 7

 

Take out the previously  installed caster and four M3 * 7.5 cap screw, and then install the parts  as demonstrated above . So, you see, one caster has been finished, and as for the other wheel , we think it is not necessary for us to repeat the installation method. Then, the whole TINY has been completed.