Octopus 3V laser sensor

Octopus 3V laser sensor is the laser emission electric brick in our Octopus series, the basic design is from the Octopus electric bricks and the setting of its outlook, the PCB fixing hole and the connectors are the same.

In stock
SKU
EF04096
$2.90

Introduction


Octopus 3V laser sensor is the laser emission electric brick in our Octopus series, the basic design is from the Octopus electric bricks and the setting of its outlook, the PCB fixing hole and the connectors are the same.

It is made of a laser emission chip, condensing lens and an adjustable sleeve, which can work after powering on.

Notice: Please do not shine the eyes. The laser emits a red laser beam that usually can be seen as a red dot, but you can only see a slight red line under the condition of frog or other medium.

Characteristics

  • The emitting principle of the laser and it's special emitting process make the laser equip the features where normal light does not have: "The Three Goods" (Good monochromaticity, good coherence and good directionality ) and "One High" (High brightness)

  • Support micro:bit in 3V.

  • Easy and convenient for connection


Parameter

ItemsParameters
Name Octopus 3V laser sensor
SKU EF04096
Working Voltage DC 3~5.5V
Wave Length 650NM
Rate of Work 5MW
Spot Size φ10mm ~ φ15mm(15 meters away)
Connection Mode G-GND,V-VCC,S-signal pin
Size 38.9x23.5mm
Net weight 5g


Dimensions and Outlook

 

Quick to Start


Hardware Connection

Connect the module with the wire(with buckle) to the PI pins on the Octopus:bit, insert the micro:bit to the Octopus:bit.

 

Software Programming

Programme in the makecode and write high level to P1 port to make the laser on and low level to make the laser off. Links: https://makecode.microbit.org/_Lvega7TP6ggz

You can also download it directly:

Result

The laser lights on.

FAQ

Write Your Own Review
You're reviewing:Octopus 3V laser sensor

No Related Posts